Ozone Gas Analyzer for Industrial Ozone Concentration Monitoring MIC100OZ Zetron

 Detection principle: Dual path ultraviolet light absorption method, using imported ultraviolet LED light source, can be used for detecting the concentration of ozone produced by the outlet gas of the ozone generator or the concentration of ozone in the exhaust gas (dehumidification device needs to be configured), and can run online in real-time 24 hours a day.

Measurement range: 0-300g/Nm3; 0-200g/Nm3； 0-100g/Nm3； 0-50g/Nm3； 0-1000ppm.

Measurement range: 0-300g/Nm3

Optional range: 0-200g/Nm3, 0-100g/Nm3, 0-50g/Nm3

Light source lifespan: approximately 50000 hours (can be used for 4-5 years);

Sampling method: positive pressure sampling, negative pressure sampling (optional);

Display interface: 7-inch touch screen operation interface;

Content interface: Ozone concentration, temperature, pressure;

Auxiliary functions: temperature compensation, pressure compensation;

Display units: g/Nm3, mg/NL,%WTAir,%WTO2 optional;

Display resolution: 0.01g/Nm3;

Gas flow rate: 0.3L-0.7L/min;

Input pressure:<0.1MPa;

Concentration error: ≤0.5% FS;

Linear error: ≤0.5% FS;

Zero drift:<± 0.3% FS；

Response time: signal 0.3 seconds, display 0.3 seconds;

Environmental temperature: -20~50 ℃;

Interface method: quick twist interface (stainless steel);

Sampling aperture: Φ 6 (6mm * 4mm);

Communication method: RS-485 Modbus RTU;

Output mode: 4-20mA (active);

Relay signal: high position relay (NO COM NC), low position relay (NO COM NC);

Power supply: AC 110-220V;

Dimensions: 350mm (height) x 270mm (width) x 150mm (depth);

Note: 1mg/L=1g/m3=467PPM;

Free warranty: 24 months (for the host sensor);

Note: Standard configuration (built-in): flowmeter, ozone exhaust catalyst, intake filter.