Cleanroom Fogger for Airflow Visualization and Smoke Testing FG-10
FG-10 Cleanroom Fogger is economical and practical type pure water fogger. It uses ultrasonic atomization principle, atomizing pure water into a lot of mist around 1-10 microns. Under external pressure, it is piped out through smoke exhaust pipe, it can exhibit thick smoke, it is very intuitive to visualize the airflow state in a number of industries, especially in the clean room industry.
Product Description
FG-10 Cleanroom Fogger is economical and practical type pure water fogger. It uses ultrasonic atomization principle, atomizing pure water into a lot of mist around 1-10 microns. Under external pressure, it is piped out through smoke exhaust pipe, it can exhibit thick smoke, it is very intuitive to visualize the airflow state in a number of industries, especially in the clean room industry.
Features
Cautions
- Keep the water tank clean.
- Please ensure that the added liquid is purified water. Otherwise it will affect the use life of the product. It is strictly forbidden to add oily media.
- Make sure the power supply is at the correct rated voltage before use.
- The chassis should be placed horizontally and should not be tilted or flipped.
- After use, turn off the power or unplug the plug and drain the remaining pure water.
- The amount of water should be added to the red line. Too much or too little water will affect the concentration of fog.
- The control circuit board should not be in contact with water to prevent short circuit
- Pay attention that the fan can not touch the water to prevent short circuit
- The water temperature in the water tank should not be higher than 50 °C.
- Avoid placing the fogger beside the electronic equipment to prevent the electrical equipment be damaged by the water mist.
- Please leave it in a dry place after use.
Technical parameters
| Model | FG-10 |
| Voltage | AC 220V |
| Power | 250W |
| Optimum capacity of water within the tank | 4 liters |
| Product size | 310 × 209 × 210 mm (length × width × height) |
| Net weight | 8 Kg, weight with water: 12Kg |
| Fogging amount | ≥ 5500ml / h |
| Atomized particle size | 1-10 micrometers |
Applications
It is suitable for semiconductor, pharmaceutical and other clean workshop acceptance air flow direction evaluation, air flow parallelism test, etc.
It is used for laminar flow test in clean room and pressure balance test inside and outside the room.
Chemical treatment equipment exhaust system test, air duct leakage test, etc.
Zetron delivers innovative solutions that boost efficiency and drive growth for your business success.
Office 19B, 17th Floor, Building 1, 48 Dongzhimenwai Avenue, Dongcheng District, Beijing